Power Balance Check

1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Power Balance Check

Fuel System Diagnosis (Power Balance Check):






Circuit Description

Refer to Diagrams/Electrical for an electrical diagram of this circuit. Electrical Diagrams

The Fuel Injector Balance Test compares the performance of each of the cylinder by using the PCM to shut off fuel injection. This measures the performance of each cylinder by the amount of RPM drop caused by that cylinder not producing a power stroke. If proper fuel delivery has been determined, then a cylinder that does not show good performance (RPM drop) indicates either an ignition or mechanical problem.

Test Description

Number(s) below refer to the step number(s) on the Diagnostic Table.

3. Idle quality should get worse when an injector is disabled. The engine should miss and the idle will become rough.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.