Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1996ELDORADO V8-4.6L VIN 9REPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
1996 Cadillac Eldorado V8-4.6L VIN 9
Cruise Control Module: Service and Repair
1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Service and Repair
1. Disconnect battery ground cable.
2. Remove lower instrument panel cover.
3. Unclip relay panel from twilight sentinel amplifier and cruise control controller mounting bracket, located to the left of the steering column.
4. Remove screws securing controller mounting bracket to instrument panel assembly.
5. Lower mounting bracket and disconnect electrical connectors from cruise control controller.
6. Remove screws securing controller to mounting bracket and remove controller.
7. Reverse procedure to install.
2. Remove lower instrument panel cover.
3. Unclip relay panel from twilight sentinel amplifier and cruise control controller mounting bracket, located to the left of the steering column.
4. Remove screws securing controller mounting bracket to instrument panel assembly.
5. Lower mounting bracket and disconnect electrical connectors from cruise control controller.
6. Remove screws securing controller to mounting bracket and remove controller.
7. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.