Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1996ELDORADO V8-4.6L VIN 9REPAIR AND DIAGNOSISCRUISE CONTROLBRAKE SWITCH (CRUISE CONTROL)DESCRIPTION AND OPERATIONBRAKE RELEASE SWITCH
1996 Cadillac Eldorado V8-4.6L VIN 9
Brake Release Switch
1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Brake Release Switch
The cruise control system utilizes an electrical brake release switch and a vacuum release valve.
The electric brake release switch cuts off the voltage supplied through the cruise control switch to the electronic controller when the brake pedal is depressed. The vacuum release valve operates after the electric release switch disengages. It serves as a back-up release system and opens a port that vents the servo unit to atmospheric pressure, allowing the throttle to return to the idle position.
The electric brake release switch cuts off the voltage supplied through the cruise control switch to the electronic controller when the brake pedal is depressed. The vacuum release valve operates after the electric release switch disengages. It serves as a back-up release system and opens a port that vents the servo unit to atmospheric pressure, allowing the throttle to return to the idle position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.