Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1996ELDORADO V8-4.6L VIN 9REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESMODE DESCRIPTIONMODE F0: DATA LIST
1996 Cadillac Eldorado V8-4.6L VIN 9
Mode F0: Data List
1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Mode F0: Data List
TEST MODES
In this mode, TECH 1 continuously monitors wheel speed data and brake switch status. When monitoring speed data, the TECH 1 screen displays signals being sent from wheel speed sensors to the EBCM. In this mode, vehicle can be driven while TECH 1 displays speed data. These readings can be compared with actual vehicle speed to check proper operation. Speed signals can also can be compared with each other to determine whether they are within specification.
If one speed signal differs greatly from another signal, improper operation of that sensor may be indicated. Intermittent speed signals can be located in the DATA LIST mode by checking for signals that vary for no reason.
In DATA LIST mode, the TECH 1 screen displays brake switch operation. When brake pedal is depressed, screen reads ON; when pedal is released, screen reads OFF.
In this mode, TECH 1 continuously monitors wheel speed data and brake switch status. When monitoring speed data, the TECH 1 screen displays signals being sent from wheel speed sensors to the EBCM. In this mode, vehicle can be driven while TECH 1 displays speed data. These readings can be compared with actual vehicle speed to check proper operation. Speed signals can also can be compared with each other to determine whether they are within specification.
If one speed signal differs greatly from another signal, improper operation of that sensor may be indicated. Intermittent speed signals can be located in the DATA LIST mode by checking for signals that vary for no reason.
In DATA LIST mode, the TECH 1 screen displays brake switch operation. When brake pedal is depressed, screen reads ON; when pedal is released, screen reads OFF.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.