Front Door

1992 Cadillac DeVille V8-300 4.9LSECTION Front Door

Power Window Regulator And Express Down Module - Front Door:






Regulator And Express Down Module

REMOVE OR DISCONNECT
1. Trim panel and water deflector.
2. Regulator to door inner panel rivets using a 6.3 mm (1/4") drill bit. Punch out rivet centers, then perform drilling operation.
3. Lock actuator linkage.
4. Regulator guide and block assembly from lower sash channel by positioning window half way down, and pushing regulator forward. Once removed, tape glass in full up position.
5. Wire connector.
6. Regulator through access hole.
7. Module to door inner panel rivets.
8. Wire Connectors.
9. Module.

INSTALL OR CONNECT
1. Position regulator to door through access hole.
2. Guide and block assembly to regulator.
3. Wire connector.
4. Regulator to door using 6.3 mm (1/4") peel type rivets.
5. Module to door using 4.8 mm (3/16 inch) rivets.
6. Wire connector.
7. Remove tape and check window operation.
8. Water deflector and trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.