Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1992DEVILLE V8-300 4.9LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIR
1992 Cadillac DeVille V8-300 4.9L
Keyless Entry Transmitter: Service and Repair
1992 Cadillac DeVille V8-300 4.9LSECTION Service and Repair
PROGRAMMING PROCEDURE
Do the following when replacing Keyless Entry Module or either transmitter.
1. Turn Ignition Switch to OFF.
2. Jumper ALDL connector terminal G (PPL/WHT) to terminal A (BLK/WHT). Door locks lock and unlock, and trunk release activates in approximately 2 seconds.
3. Press any button on one transmitter. Door locks lock and unlock, and trunk release activates in approximately 2 seconds. The first transmitter is now programmed.
4. Repeat step 3 using the other transmitter. If only one transmitter is being used, go to step 5.
5. Disconnect jumper from ALDL connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.