Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Conditions
Codes EO14, EO15, EO16, EO21, EO22, EO26, EO27, EO31, EO32, and EO34 not set. Throttle switch open, throttle angle 6-30 degrees, coolant sensor greater than or equal to 136°F (58°C), oxygen sensor ready (closed loop), RPM greater than or equal to 800 and canister purge has occurred at full duty cycle 10 minutes since engine was running with coolant 176°F (80°C) and throttle angle 10 degrees or greater.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.