Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1983ELDORADO V8-350 5.7L DSLREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
1983 Cadillac Eldorado V8-350 5.7L DSL
Cruise Control Switch: Service and Repair
1983 Cadillac Eldorado V8-350 5.7L DSLSECTION Service and Repair
The engagement switch cannot be serviced. The complete turn signal lever must be replaced as an assembly.
1. Disconnect battery ground cable.
2. Remove steering column lower cover and remove tape securing wire to column.
3. Disconnect cruise control switch connector and attach a suitable piece of wire to switch connector.
4. Remove turn signal lever by pulling it out of the detented retaining clip inside the steering column. On some models, it may be necessary to remove steering wheel.
5. Pull harness up gently so guide wire can be used to install new unit.
6. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.