Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2019 Buick Envision BaseSECTION Installation Procedure
- Connect the electrical connectors.
- Connect the connector position assurance (CPA) retainer.
Align the 2 top steering wheel airbag fasteners (1) to the steering wheel spring fasteners.
- Push the steering wheel airbag (1) firmly into the steering wheel in order to engage both upper spring fasteners.
- After both upper spring fasteners snapped in steering wheel, push the lower area of the steering wheel airbag (1) to engage the lower spring fastener.
- Enable the SIR System. SIR Disabling and Enabling .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.