Front Floor Console Replacement

2019 Buick Envision BaseSECTION Front Floor Console Replacement
GM3914415Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Shift the transmission into DRIVE.
  2. Transmission Control Lever Knob Replacement
  3. Front Floor Console Extension Panel Replacement - Left Side 
  4. Front Floor Console Extension Panel Replacement - Right Side 
  5. Remove the right side instrument panel center lower bracket. Instrument Panel Center Lower Bracket Replacement 
1 Front Floor Console Bolt Access Hole Cover [2x]
Procedure 
Use a flat bladed plastic trim tool.
2 Front Floor Console Bolt [8x]
CAUTION:

Refer to Fastener Caution .


Tighten 
7 N.m (62 lb in)
3 Front Floor Console
NOTE:

When installing the front floor console take care in seating the auxiliary air conditioning air outlet duct to the front floor console rear air duct.

Procedures

  1. Disconnect electrical connections, if applicable.
  2. With the aid of an assistant, lift the floor console rearward and upward away from the instrument panel assembly.
  3. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.