Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2019ENVISION BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM AND PANELINGREPAIR INSTRUCTIONSQUARTER WINDOW TRIM FINISH PANEL REPLACEMENT

2019 Buick Envision Base

Quarter Window Trim Finish Panel Replacement

2019 Buick Envision BaseSECTION Quarter Window Trim Finish Panel Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures SIR Disabling and Enabling Quarter Lower Rear Trim Panel Replacement Remove the rear seat lower anchor plate bolt on the side of the trim panel being replaced Rear Seat Belt Retractor Replacement
1	Quarter Window Trim Finish Panel Bolt Cap [2x]
2	Quarter Window Trim Finish Panel Fastener [2x] CAUTION: Refer to Fastener Caution . Tighten 3 N.m (27 lb in)
3	Quarter Window Trim Finish Panel Procedure Use a flat bladed plastic trim tool. Route the seat belt through trim panel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.