SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2019ENVISION BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIMREPAIR INSTRUCTIONSFRONT FOG LAMP BEZEL INSERT REPLACEMENT
2019 Buick Envision Base

Front Fog Lamp Bezel Insert Replacement

2019 Buick Envision BaseSECTION Front Fog Lamp Bezel Insert Replacement
GM4822353Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Front Bumper Fascia Replacement
  2. Remove the appropriate front fog lamp:
1 Front Grille Retainer [2x]
2 Front Fog Lamp Bezel Insert

Procedure

  1. Place the bumper fascia face down on a clean protective surface.
  2. Release the locking tabs from the front fascia and pull front fog lamp bezel insert forward.
  3. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.