Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2019 Buick Envision BaseSECTION Circuit/System Verification
- Ignition On/Vehicle in Service Mode. Infotainment system ON.
- Verify DTC B101E is not set
- If DTC B101E is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If DTC B101E is not set
- If DTC B101E is set
- Verify DTC B0997 is not set
- If DTC B0997 is set
Replace the P17 Info Display Module.
- Go to next step: If DTC B0997 is not set
- If DTC B0997 is set
- All OK
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.