Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Parking Assist Alarm Sensor Bracket Replacement: Notes
Removal Procedure
Rear Bumper Fascia (4) - Remove - Rear Bumper Fascia Replacement
Rear Parking Assist Alarm Sensor (1) - Remove - Rear Parking Assist Alarm Sensor Replacement
Using a flat bladed tool, carefully remove the rear parking assist alarm sensor bracket (1) from the fascia.
- NOTE:
Do Not sand/grind off alignment tabs outline.
Using an appropriate tool, sand/grind sonic weld plastic residue from the fascia (1).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.