Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2019 Buick Envision BaseSECTION Circuit/System Verification
- Ignition ON.
- Verify the scan tool Park Assist Switch parameter changes between Active and Inactive when cycling the parking assist switch.
- If the parameter does not change between Active and Inactive
Refer to Parking Assist Switch Malfunction.
- Go to next step: If the parameter changes between Active and Inactive
- If the parameter does not change between Active and Inactive
- Verify the Park Assist Switch Indicator turns ON and OFF when cycling the parking assist switch.
- If the indicator does not turn ON and OFF
Refer to Parking Assist Indicator Malfunction.
- Go to next step: If the indicator turns ON and OFF
- If the indicator does not turn ON and OFF
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.