Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Video Processing Control Module Calibration (with UVH): Notes
Image will be slightly distorted at all times, the camera(s) lens is a fish-eye lens meant to capture as much as possible.
The calibration procedure allows the Video Processing Control Module to learn new cameras and their positions. The calibration procedure can be initiated by selecting Video Processing Control Module Camera Learn in the scan tool.
Radio Display Prompt Example
Only ONE EL-51372 Camera Calibration Mat is required for calibration.
The left side of the screen will display where the EL-51372 Camera Calibration Mat should be located for each step. The right side of the display is the view from the camera that is being learned during that step.
Mat Position Reference
- Position A is the left front
- Position B is the right front
- Position C is the left rear
- Position D is the right rear
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.