Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
2019 Buick Envision BaseSECTION Circuit/System Testing
- Ignition OFF/Vehicle OFF, disconnect the radio antenna coax cable from the A11 Radio and from the T23 Radio Antenna Amplifier.
- Verify the antenna coax cable passes the coax cable component test. Refer to Component Testing.
- If the coax cable does not pass the testÂ
Replace the antenna coax cable
- Go to next step: If the coax cable passes the testÂ
- If the coax cable does not pass the testÂ
- Connect the antenna coax cable to the A11 Radio. Ignition ON/Vehicle in Service Mode, A11 Radio ON.
- Verify a test lamp illuminates between the antenna coax cable center terminal and ground at the T23 Radio Antenna Amplifier connector.
- If the test lamp does not illuminateÂ
Replace the A11 Radio.
- Go to next step: If the test lamp illuminatesÂ
- If the test lamp does not illuminateÂ
- Test or replace the T23 Radio Antenna Amplifier.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.