Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SIR/SRS Wire Repair
Do not install more than 2 DuraSeal splice sleeves per SIR deployment loop. A deployment loop consists of both wires from the K36 Inflatable Restraint Sensing and Diagnostic Module to the deployable component. If more than 2 DuraSeal splice sleeves are required for any SIR deployment loop, the complete circuit of the loop must be replaced. More than 2 DuraSeal splice sleeves per deployment loop may increase the resistance in the circuit causing a DTC to be set.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.