Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Battery Distribution Engine Compartment Fuse Block (1) - Install
- CAUTION:
Refer to Fastener Caution .
Positive Battery Clamp Nut (1) - Install and tighten 9 N.m (80 lb in)
- Connect all electrical connectors.(1)
Generator and Battery Cable (2) - Install
- Generator and Battery Cable Nut (1) - Install and tighten 16 N.m (12 lb ft)
Front Compartment Fuse Block Cover (1) - Install
- Rear Compartment Side Trim Replacement - Left Side (5-Door Wagon 35)Rear Compartment Side Trim Replacement - Left Side (Hatchback) - Connect
- BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION (3.6L LGX)BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION (2.0L LTG) - Install
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.