Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCORE BASE, AWDREPAIR AND DIAGNOSISSTEERINGPOWER STEERING SYSTEMREPAIR INSTRUCTIONSPOWER STEERING SYSTEM BLEEDING
2016 Buick Encore Base, AWD
Power Steering System Bleeding
2016 Buick Encore Base, AWDSECTION Power Steering System Bleeding
- Use clean, new power steering fluid only. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Hoses touching the frame, body or engine may cause system noise. Ensure the hoses do not touch any other part of the vehicle.
- Loose connections may not leak, but could allow air into the steering system. Ensure all hose connections are tight.
- Maintain the power steering fluid level throughout the bleeding procedure.
- Fill the power steering fluid reservoir with fluid to the minimum system level, the FULL COLD level, or the middle of the hash mark on the cap stick fluid level indicator, as applicable.
- Raise the vehicle until the front wheels are off the ground. Refer to Lifting and Jacking the Vehicle .
- With the key in the ON position and with the engine OFF, turn the steering wheel from stop to stop 12 times.
If the vehicle is equipped with longer length power steering hoses, turn the steering wheel from stop to stop 15 to 20 times.
- Verify the power steering fluid level. Refer to Checking and Adding Power Steering Fluid .
- Start the engine. Rotate the steering wheel from left to right. Inspect the power steering system for signs of cavitation or fluid aeration, like pump noise or whining.
- Verify the fluid level. Repeat the bleed procedure, if necessary.
- Lower the vehicle.
NOTE:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.