SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCORE BASE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKIMMOBILIZER SYSTEMREPAIR INSTRUCTIONSTHEFT DETERRENT MODULE REPLACEMENT (TRAX)
2016 Buick Encore Base, AWD

Theft Deterrent Module Replacement (Trax)

2016 Buick Encore Base, AWDSECTION Theft Deterrent Module Replacement (Trax)
Fig 1: Theft Deterrent Module (Trax)
GM2876782Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement (Trax) .
  2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Trax) .
1 Theft Deterrent Module Fastener (Qty: 2)
CAUTION:

Refer to Fastener Caution .
2 Theft Deterrent Module

Procedure

  1. Disconnect the electrical connector.
  2. Slide the module up to remove from the ignition and start switch housing.
  3. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.