Driver Seat Heater Switch Replacement

2016 Buick Enclave ConvenienceSECTION Driver Seat Heater Switch Replacement
Fig 1: Driver Seat Heater Switch
GM1828467Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the front floor console accessory trim plate. Refer to Front Floor Console Accessory Trim Plate Replacement (Acadia)Front Floor Console Accessory Trim Plate Replacement (Enclave)Front Floor Console Accessory Trim Plate Replacement (Traverse) .
1 Front Floor Console Accessory Switch Mounting Plate Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Front Floor Console Accessory Switch Mounting Plate
Procedure 
Disconnect the electrical connectors.
3 Seat Heater Switch (Qty: 2)
Procedure 
Disengage the heated seat switches from the accessory switch mounting plate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.