2016 Buick Cascada BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: Quarter Inner Trim Finish Panel - Left Side
    GM2949064Courtesy of GENERAL MOTORS COMPANY
  1. Remove the quarter inner trim finish panel - left side (4). Refer to Quarter Inner Trim Finish Panel Replacement - Left Side .
  2. Fig 2: Rear Seat Back Armrest Hinge Bracket And Clip
    GM3011724Courtesy of GENERAL MOTORS COMPANY
  3. Remove the retainer clip (2).
  4. Remove the rear seat back armrest hinge bracket (1).
  5. Fig 3: Fuse Block Bracket Nuts And Electrical Connectors
    GM3011723Courtesy of GENERAL MOTORS COMPANY
  6. Remove the 3 fuse block bracket nuts (2).
  7. Disconnect the wiring harness plug (1).
  8. Fig 4: Wiring Harness Plugs
    GM3137424Courtesy of GENERAL MOTORS COMPANY
  9. Turn the fuse block bracket down in a horizontal position.
  10. Disconnect the 3 wiring harness plugs (1).
  11. Unclip the front and rear object alarm module (2) from the 3 fuse block brackets.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.