Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015REGAL BASE, 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETUNE-UPENGINE CONTROLS AND FUEL - 2.0L (LTG) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL PUMP FLOW CONTROL MODULE REPLACEMENT
2015 Buick Regal Base, 2.0L Eng VIN X, AWD
Fuel Pump Flow Control Module Replacement
2015 Buick Regal Base, 2.0L Eng VIN X, AWDSECTION Fuel Pump Flow Control Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the passenger rear side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (HP6, Right Side) . |
|
| 1 | Fuel Pump Flow Control Module Fastener
CAUTION:
Refer to Fastener Caution . Tighten 9 N.m (80 lb in) |
| 2 | Fuel Pump Flow Control Module Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.