SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015REGAL BASE, 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSKEYLESS ENTRY CONTROL MODULE REPLACEMENT
2015 Buick Regal Base, 2.0L Eng VIN X, AWD

Keyless Entry Control Module Replacement

2015 Buick Regal Base, 2.0L Eng VIN X, AWDSECTION Keyless Entry Control Module Replacement
Fig 1: Keyless Entry Control Module
GM2193978Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
1 Wiring Harness Bracket
Procedure 
Release the wiring harness bracket.
2 Keyless Entry Control Module

Procedure

  1. Disconnect the wiring harness connectors.
  2. Clip out the fixing points from the keyless entry control module.
  3. Remove the keyless entry control module.
  4. After repairs, for programming and set up information. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.