SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015REGAL BASE, 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEMREPAIR INSTRUCTIONSPARKING ASSIST CONTROL MODULE REPLACEMENT
2015 Buick Regal Base, 2.0L Eng VIN X, AWD

Parking Assist Control Module Replacement

2015 Buick Regal Base, 2.0L Eng VIN X, AWDSECTION Parking Assist Control Module Replacement
Fig 1: Rear Object Alarm Module
GM2207705Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (HP6, Left Side) , Rear Compartment Side Trim Panel Replacement (without HP6) or Rear Compartment Side Trim Panel Replacement (HP6, Right Side) .
1 Rear Object Alarm Module Assembly

Procedure

  1. Disconnect the electrical connectors.
  2. Release the locking retainer from the front and rear object alarm module bracket.
  3. For programming and set up, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.