Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015REGAL BASE, 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC C0460: STEERING WHEEL ANGLE SENSOR MODULE (DISTANCE SENSING CRUISE CONTROL)CIRCUIT/SYSTEM VERIFICATION
2015 Buick Regal Base, 2.0L Eng VIN X, AWD
Circuit/System Verification
2015 Buick Regal Base, 2.0L Eng VIN X, AWDSECTION Circuit/System Verification
- Vehicle in Service Mode.
- Verify that DTC C0460 3A is not set.
- If the DTC is set
- Install the correct part number B99Steering Wheel Angle Sensor. Clear DTCs and retest.
- Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC.
- If the DTC sets, replace the K14 Distance Sensing Cruise Control Module.
- If the DTC is not set.
- All OK.
- If the DTC is not set
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.