SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015REGAL BASE, 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSAIR INLET GRILLE PANEL REPLACEMENT
2015 Buick Regal Base, 2.0L Eng VIN X, AWD

Air Inlet Grille Panel Replacement

2015 Buick Regal Base, 2.0L Eng VIN X, AWDSECTION Air Inlet Grille Panel Replacement
Fig 1: Air Inlet Grille Panel & Retainers
GM2202210Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
1 Push-Pin Retainer (Qty:4)
TIP:  Lift the center of the push pin, then remove the lower portion from the grille panel.
2 Air Inlet Grille Panel

Procedure

  1. Disconnect the hood rear weather-strip from the air inlet panel flange.
  2. Lift the front edge of the air inlet panel upward off the plenum edge far enough to clear the wiper motor pivot shafts.
  3. Disengage the washer hose from the bottom edge of the panel.
  4. Starting at the rear corner of the air inlet grille, lift the grille from the windshield trim and release across to the other side before pulling the air inlet grille forward.
  5. Pull the grille forward to disengage the rear edge of the grille panel from the bottom of the windshield edge.
  6. Pull the air inlet grille panel from around both hood hinges.
  7. Angle the air inlet grille to clear the hood strut assembly.
  8. Transfer the windshield washer nozzles. Refer to Windshield Washer Nozzle Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.