Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015ENCLAVE CONVENIENCEREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROLS AND FUEL - 3.6L (LLT) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSCAMSHAFT POSITION ACTUATOR SOLENOID VALVE SOLENOID REPLACEMENT - BANK 2 (LEFT SIDE) EXHAUSTREMOVAL PROCEDURE
2015 Buick Enclave Convenience
Removal Procedure
2015 Buick Enclave ConvenienceSECTION Removal Procedure
- Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
- Disconnect the engine wiring harness electrical connector (5) from the bank 2 exhaust camshaft position (CMP) actuator solenoid valve.
- Remove the CMP actuator solenoid valve bolt and valve (4).
- Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.