SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015ENCLAVE CONVENIENCEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM AND INTERIOR PANELINGREPAIR INSTRUCTIONSQUARTER LOWER REAR TRIM PANEL REPLACEMENT (TRAVERSE WITH TB4)
2015 Buick Enclave Convenience

Quarter Lower Rear Trim Panel Replacement (Traverse with TB4)

2015 Buick Enclave ConvenienceSECTION Quarter Lower Rear Trim Panel Replacement (Traverse with TB4)
Fig 1: Identifying Rear Quarter Lower Trim Panel (Traverse Without TB4)
GM1899818Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Move the rear seat to the full forward position.
  2. Remove the rear number 2 seat . Refer to 3rd Row Seat Removal and Installation .
  3. Remove the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement (TB4) .
  4. Disconnect the liftgate actuator rod from the liftgate. Refer to Liftgate Actuator Rod Replacement .
  5. Disconnect the rear seat number 2 shoulder belt anchor bolt. Refer to 3rd Row Seat Retractor Side Belt Replacement .
  6. Remove the liftgate door sill plate. Refer to Liftgate Door Sill Plate Replacement (Traverse) .
1 Cargo Tie Down Loop Bolt Cap (Qty: 2)
2 Cargo Tie Down Loop Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
3 N.m (27 lb in)
3 Cargo Tie Down Loop (Qty: 2)
4 Body Side Trim Panel Armrest
Procedure 
Pull upward on the armrest to disengage the retainer clips.
5 Cargo Screen Retainer Assembly (Qty: 2)

Procedure

  1. Turn the left front and right rear cargo screen retainer counterclockwise one quarter turn to disengage the 2 integral tabs.
  2. Turn the left rear and right front cargo screen retainer clockwise one quarter turn to disengage the 2 integral tabs.
6 Rear Quarter Lower Trim Push Nut (Qty: 2)
7 Rear Quarter Lower Trim Panel Assembly

Procedure

  1. Pull outward to disengage the trim panel retainers.
  2. Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.