SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015ENCLAVE CONVENIENCEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REPLACEMENTREMOVAL PROCEDURE
2015 Buick Enclave Convenience

Removal Procedure

2015 Buick Enclave ConvenienceSECTION Removal Procedure
  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Enclave)Rear Side Door Trim Panel Replacement (Acadia or Traverse) .
  2. Remove the water deflector.
    3. NOTE:

    Tape the edges of the outer belt sealing strip to pinch weld to protect the paint.

  3. Remove the outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (Acadia/Traverse) Rear Side Door Window Outer Sealing Strip Replacement (Enclave) .
    4. Fig 1: Identifying Rear Door Window Guide Bolts
    GM1843926Courtesy of GENERAL MOTORS COMPANY
  4. Lower the window (1) to align the bolts (2) with the access holes in the inner panel.
  5. Remove the window guide bolts (2).
  6. Using masking tape place the door window into the upper door frame and tape in place.
  7. Remove the window regulator. Refer to Rear Side Door Window Regulator Replacement .
  8. Remove the rear door speaker. Refer to Radio Rear Side Door Speaker Replacement .
  9. Remove the rear door window front channel. Refer to Rear Side Door Window Front Channel Replacement (Acadia/Traverse) .
  10. Remove the masking tape from the window and frame.
    11. Fig 2: Identifying Rear Side Door Window
    GM1971241Courtesy of GENERAL MOTORS COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.