Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2014ENCLAVE CONVENIENCEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMEXTERIOR TRIMREPAIR INSTRUCTIONSROCKER PANEL FRONT MOLDING REPLACEMENT (TRAVERSE)

2014 Buick Enclave Convenience

Rocker Panel Front Molding Replacement (Traverse)

2014 Buick Enclave ConvenienceSECTION Rocker Panel Front Molding Replacement (Traverse)

Fig 1: Rocker Panel Front Molding (Traverse)

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedures

Open front and rear side doors.
Remove the front and rear side door lower weatherstrip. Refer to Front or Rear Side Door Lower Weatherstrip Replacement .

Front Wheelhouse Liner Bolt (Qty: 4)

CAUTION: Refer to Fastener Caution .

Rocker Panel Front Molding
Procedure
Using a trim-type release tool start from the front end of the rocker panel front molding and release the 21 retainers.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.