SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2014ENCLAVE CONVENIENCEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW FRAME REAR APPLIQUE REPLACEMENT
2014 Buick Enclave Convenience

Rear Side Door Window Frame Rear Applique Replacement

2014 Buick Enclave ConvenienceSECTION Rear Side Door Window Frame Rear Applique Replacement
Fig 1: Identifying Rear Side Door Window Frame Rear Applique
GM3409194Courtesy of GENERAL MOTORS COMPANY
Rear Side Door Window Frame Rear Applique Replacement

Callout Component Name
Preliminary Procedure 
Remove the rear side door window outer sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (Acadia/Traverse) , Rear Side Door Window Outer Sealing Strip Replacement (Enclave) .
1 Rear Side Door Window Frame Rear Applique Fastener (Qty: 3)
WARNING: Refer to Glass and Sheet Metal Handling Warning

Procedure

  1. Lower the window to the fully down position.
  2. Pull the rear side door window weatherstrip away from the applique to expose the rivets.
  3. When drilling cover/protect the interior trim and door from the metal shavings.
  4. Using a suitable tool, drill out the rivets from the rear door frame applique.
2 Rear Side Door Window Frame Rear Applique
Procedure 
Use a suitable tool, install the rivets in the rear side door frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.