Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2014ENCLAVE CONVENIENCEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B2495: LIFTGATE LATCH RELEASE/CINCH MALFUNCTIONCOMPONENT TESTING
2014 Buick Enclave Convenience
Component Testing
2014 Buick Enclave ConvenienceSECTION Component Testing
- Install a 20 A fused jumper wire between the control terminal 1 and 12 V. Momentarily install a jumper wire between the control terminal 3 and ground. The liftgate latch assembly should perform the CINCH or RELEASE function.
- If the function does not perform as specified, replace the liftgate latch assembly.
- Reverse the jumper wires; the liftgate latch assembly should perform the RELEASE or CINCH function.
- If the function does not perform as specified, replace the liftgate latch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.