Electronic Suspension Control Module Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Electronic Suspension Control Module Replacement
Fig 1: Electronic Suspension Control Module Components
GM2740006Courtesy of GENERAL MOTORS COMPANY
Electronic Suspension Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the left side luggage compartment trim. Refer to Rear Compartment Side Trim Panel Replacement (without HP6) , Rear Compartment Side Trim Panel Replacement (HP6, Left Side) , Rear Compartment Side Trim Panel Replacement (HP6, Right Side) .
1 Electronic Suspension Control Module Bracket Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
9 (80 lb in)
2 Electronic Suspension Control Module Bracket
3 Electronic Suspension Control Module Electrical Harness Connector
4 Electronic Suspension Control Module
Procedure 
For programming and setup information, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.