SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISSTEERINGPOWER STEERING SYSTEMREPAIR INSTRUCTIONSSTEERING POWER VARIABLE CONTROL MODULE REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Steering Power Variable Control Module Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Steering Power Variable Control Module Replacement
Fig 1: Steering Power Variable Control Module
GM2019046Courtesy of GENERAL MOTORS COMPANY
Steering Power Variable Control Module Replacement

Callout Component Name

Procedure

  1. Disconnect the battery, refer to Battery Negative Cable Disconnection and Connection
  2. Remove the Instrument panel lower trim panel insulator, refer to Instrument Panel Lower Trim Panel Insulator Replacement
1 Steering Power Variable Control Module

Procedure

  1. Release the control module from its clips.
  2. Disconnect the connector from the control module.
  3. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.