SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSINFLATABLE RESTRAINT CONTROL MODULE REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Inflatable Restraint Control Module Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Inflatable Restraint Control Module Replacement
Fig 1: Inflatable Restraint Control Module
GM2020274Courtesy of GENERAL MOTORS COMPANY
Inflatable Restraint Control Module Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the front floor console extension panel. Refer to Front Floor Console Extension Panel Replacement .
1 Instrument Panel Tie Bar Brace Fastener (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Procedure 
Move the front floor carpet left side in the area of the front floor console.
Tighten 
22 N.m (16 lb ft)
2 Instrument Panel Tie Bar Brace
3 Inflatable Restraint Control Module Fastener (Qty: 3)

Procedure

  1. Remove the adapter from the floor rear air outlet duct left side.
  2. Disconnect the electrical connectors.

Tighten 
10 N.m (89 lb in)
4 Inflatable Restraint Control Module

Procedure

  1. Tighten down the inflatable restraint control module by all three fasteners.
  2. Connect the electrical connectors.
  3. Program the inflatable restraint control module after replacement. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.