Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (VEHICLE DIAGNOSTIC INFORMATION - SPECIFICATIONS - SCAN TOOL DATA - ECM (LUK) TO TCM)SPECIFICATIONSINSTRUMENT CLUSTER SCAN TOOL INFORMATION
2013 Buick Regal Turbo Premium, Standard Trans
Instrument Cluster Scan Tool Information
2013 Buick Regal Turbo Premium, Standard TransSECTION Instrument Cluster Scan Tool Information
WARNING: This page is about a different variant/trim than selected.
Instrument Cluster Scan Tool Data Parameters
| Parameter | Expected Value | Description |
|---|---|---|
| Operating Conditions: Ignition ON | ||
| Ambient Air Temperature | Ambient Temperature | The scan tool displays outside temperature in °C or °F. |
| Battery Voltage | 12-14 V | The scan tool displays Volts. This is the current battery voltage signal. |
| Coolant Level Switch | Open | The scan tool displays either Open, Closed, or Not Available. |
| Driver Information Center Reset Switch | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the driver information center reset switch. |
| Driver Information Center Switch | Varies | The scan tool displays Volts. This is the current driver information center switch input voltage. |
| Inactive | The scan tool displays either Inactive, Up, Down, or Menu. This is the state of the driver information center switch. | |
| Key in Ignition Status | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the key in ignition switch. |
| Engine Speed | Varies | The scan tool displays the current engine speed in RPM. |
| Vehicle Speed | Varies | The scan tool displays the current vehicle speed in MPH or KPH. |
| Washer Fluid Level Switch | Open | The scan tool displays either Open, Closed, or Not Available. |
Instrument Cluster Scan Tool Output Controls
| Output Control | Description |
|---|---|
| All Indicators | This function is used to command all the indicators ON or OFF. |
| CAN Bus Configuration Learn | This function is used to Reset the source ID for low speed CAN Bus communications. |
| Driver Information Center Dimming | This function is used to command the dimming of the driver information display to Increase or Decrease by 10%. |
| Driver Information Center Options | This function is used to command the driver information center buttons using the scan tool. |
| Driver Information Center Segments | This function is used to command the driver information center segments ON and OFF. |
| Instrument Cluster Gauge Sweep | This function is used to command the gauges to sweep from minimum to maximum. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.