Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROLS/FUEL - 2.4L (LUK) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSMASS AIRFLOW SENSOR WITH INTAKE AIR TEMPERATURE SENSOR REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans
Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
2013 Buick Regal Turbo Premium, Standard TransSECTION Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
| Callout | Component Name |
|---|---|
| 1 | Mass Airflow Sensor Fastener (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 4 N.m(35 lb in) |
| 2 | Mass Airflow Sensor Procedure Disconnect the electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.