Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROLS/FUEL - 2.4L (LUK) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSFUEL LEVEL SENSOR REPLACEMENTINSTALLATION PROCEDURE
2013 Buick Regal Turbo Premium, Standard Trans
Installation Procedure
2013 Buick Regal Turbo Premium, Standard TransSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Push in the electrical terminals (1) and ensure the terminals are secure.
- Carefully insert the level sensor until the locking tabs (1) snap into the locking position.
- Install the fuel tank pump module. Refer to Fuel Tank Fuel Pump Module Replacement (NU6) , Fuel Tank Fuel Pump Module Replacement (NT7) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.