Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (HYBRID/EV CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P1A6FCIRCUIT/SYSTEM VERIFICATION
2013 Buick Regal Turbo Premium, Standard Trans
Circuit/System Verification
2013 Buick Regal Turbo Premium, Standard TransSECTION Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- If drive belt noise was noticed on an AutoStart, refer to Drive Belt Tensioner Diagnosis .
- Verify that no other hybrid control module or engine control modules DTCs are set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If the DTC is set, program the K59 starter generator control module.
- If the DTC resets, replace the K59 starter generator control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.