Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reference Information
Schematic Reference
Connector End View Reference
COMPONENT CONNECTOR END VIEWS -- INDEX
Description and Operation
Evaporative Emission Control System Description
Electrical Information Reference
- Circuit Testing
- Connector Repairs
- Testing for Intermittent Conditions and Poor Connections
- Wiring Repairs
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Special Tools
- CH 48096: Evaporative Emissions Service Access Port Tool
- J 41415-30: Fuel Tank Adapter
- J 41413-200: Evaporative Emissions System Tester (EEST)
- J 41413-300: Evaporative Emissions Cap and Plug Kit
- J 41413-311: Evaporative Emissions Plug
- J 41413-SPT: High Intensity White Light
- J 41413-VLV: Evaporative Emissions Service Port Vent Tool
- For equivalent regional tools, refer to Special Tools .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.