SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 79 (OBJECT DETECTION SYSTEM - PARK ASSIST SYSTEM)REPAIR INSTRUCTIONSREAR OBJECT ALARM MODULE REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Rear Object Alarm Module Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Rear Object Alarm Module Replacement
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Object Alarm Module
GM2207705Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement .
1 Rear Object Alarm Module Assembly

Procedure

  1. Disconnect the electrical connectors.
  2. Release the locking retainer from the front and rear object alarm module bracket.
  3. For programming and set up, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.