Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 47 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER MOTOR REPLACEMENT

2013 Buick Regal Turbo Premium, Standard Trans

Windshield Wiper Motor Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Windshield Wiper Motor Replacement

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Wiper Motor

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure:
Remove the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement .

Windshield Wiper Motor Bolt (Qty: 3)

CAUTION: Refer to Fastener Caution .

Tighten: 10 N.m (89 lb in)

Windshield Wiper Motor Assembly

Procedure

The NEW wiper motor is shipped with the crank arm out of the PARK Position.
Using the J-39232: separator or equivalent, disconnect the crank arm ball socket from the wiper transmission link.
Using the J-39529: installer or equivalent, connect the crank arm ball socket to the wiper transmission link.
Install the NEW wiper motor to the transmission as shipped.
Install the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement .

Special Tools

J-39232: Wiper Linkage Separator
J-39529: Wiper Linkage Installer

For equivalent regional tools, refer to Special Tools .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.