Circuit/System Testing

2013 Buick Regal Turbo Premium, Standard TransSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the M27 fuel door release actuator.
  2. Connect a test lamp between the control circuit terminal 1 and control circuit terminal 2.
  3. Command the door latches to LOCK and UNLOCK with a scan tool, the test lamp should briefly illuminate while changing between the commanded states.
    • If the test lamp is always OFF, test either control circuit for an open/high resistance.
  4. If all circuits test normal, test or replace the M27 fuel door release actuator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.