Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 33 (FRAME AND UNDERBODY)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2013 Buick Regal Turbo Premium, Standard Trans
Fastener Tightening Specifications
2013 Buick Regal Turbo Premium, Standard TransSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Frame-to-Body Bolts | 160 N.m | 118 lb ft |
| Frame-to-Body Reinforcement Bolts | 60 N.m + 30 degrees | 44 lb ft + 30 degrees |
| Front Transmission Mount-to-Frame Bolt | 100 N.m | 74 lb ft |
| Front Wheelhouse Liner - Front Screws | 2.5 N.m | 22 lb in |
| Rear Transmission Mount-to-Frame Bolt | 100 N.m | 74 lb ft |
| Rear Support to Body Bolts | 90 N.m + 180 degrees + 15 degrees | 66 lb ft + 180 degrees + 15 degrees |
| Rear Wheelhouse Panel Liner Nuts | 1.8 N.m | 15 lb in |
| Rear Wheelhouse Panel Liner Screws | 3 N.m | 27 lb in |
| Reinforcements Arm Bolts | 150 N.m + 30 degrees + 15 degrees | 111 lb ft + 30 degrees + 15 degrees |
| Stabilizer Shaft Clamp Fasteners | 22 N.m + 30 degrees + 15 degrees | 16 lb ft + 30 degrees + 15 degrees |
| Steering Gear Bolt | 110 N.m + 150 degrees + 15 degrees | 81 lb ft + 150 degrees + 15 degrees |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.