SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 32 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSREAR SEAT SIDE INFLATABLE RESTRAINT MODULE REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Rear Seat Side Inflatable Restraint Module Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Rear Seat Side Inflatable Restraint Module Replacement
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seat Side Inflatable Restraint Module
GM2213612Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
  • The seat cushion frame
  • The seat recliner, if equipped
  • The seat adjuster
  • The seat back frame

Failure to do so may cause future personal injury.

Preliminary Procedure

  1. Disable the SIR system, if equipped. Refer to SIR Disabling and Enabling .
  2. Remove the rear seat back cushion bolster. Refer to Rear Seat Back Cushion Bolster Replacement .
1 Rear Seat Side Inflatable Restraint Module Bracket Bolt (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  3.5 N.m (31 lb in)
2 Rear Seat Side Inflatable Restraint Module Nut (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  3.5 N.m (31 lb in)
3 Rear Seat Side Inflatable Restraint Module Bracket
4 Rear Seat Side Inflatable Restraint Module

Procedure

  1. Remove the connector position assurance (CPA) from the module electrical connector.
  2. Disconnect the electrical connector.
  3. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflatable Restraint Module Handling and Scrapping .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.