Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 197 (HYBRID/EV CONTROL SYSTEM)SPECIFICATIONSTEMPERATURE VERSUS RESISTANCE
2013 Buick Regal Turbo Premium, Standard Trans
Temperature Versus Resistance
2013 Buick Regal Turbo Premium, Standard TransSECTION Temperature Versus Resistance
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Drive Motor Temperature Sensor
| °C | °F | OHMS (±10%) |
|---|---|---|
| Temperature vs Resistance Values (Approximate) | ||
| 220 | 428 | 130 |
| 210 | 410 | 155 |
| 200 | 392 | 187 |
| 190 | 374 | 228 |
| 180 | 356 | 279 |
| 170 | 338 | 345 |
| 160 | 320 | 430 |
| 150 | 302 | 542 |
| 140 | 284 | 689 |
| 130 | 266 | 887 |
| 120 | 248 | 1155 |
| 110 | 230 | 1525 |
| 100 | 212 | 2036 |
| 90 | 194 | 2750 |
| 80 | 176 | 3775 |
| 70 | 158 | 5270 |
| 60 | 140 | 7500 |
| 50 | 122 | 10, 800 |
| 40 | 104 | 16, 050 |
| 30 | 86 | 24, 270 |
| 20 | 68 | 37, 300 |
| 10 | 50 | 59, 100 |
| 0 | 32 | 96, 200 |
| -10 | 14 | 162, 500 |
| -20 | -4 | 283, 600 |
| -30 | -22 | 513, 000 |
| -40 | -40 | 965, 600 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.