SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 164 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE DOOR OUTSIDE HANDLE BRACKET REPLACEMENT (BASE)
2013 Buick Regal Turbo Premium, Standard Trans

Front Side Door Outside Handle Bracket Replacement (Base)

2013 Buick Regal Turbo Premium, Standard TransSECTION Front Side Door Outside Handle Bracket Replacement (Base)
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Door Outside Handle Bracket (Base)
GM2019711Courtesy of GENERAL MOTORS COMPANY
Front Side Door Outside Handle Bracket Replacement (Base)

Callout Component Name

Preliminary Procedures

  1. Remove the front side door water deflector. Refer to Front Side Door Water Deflector Replacement .
  2. Remove the front side door outside handle. Refer to Front Side Door Outside Handle Replacement (Passive Entry ATH) , Front Side Door Outside Handle Replacement (Base) .
1 Front Side Door Outside Handle Bracket Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
5 N.m (44 lb in)
2 Front Side Door Outside Handle Bracket

Procedure

  1. Release front side door outside handle rod mechanism at shift linkage lever - clip.
  2. Release the front side door lock cylinder rod from the door lock.
  3. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.