Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
When any exterior door handle is lifted, switched ground signals are sent to the keyless entry control module through the door handle switch signal circuits. Upon receipt of these inputs, the keyless entry control module will check the door lock status of the following inputs:
- Driver door handle is still pulled
- An unlatch enable signal from the BCM has been received
Once the enable criteria has been met, the keyless entry control module will supply power and ground to door unlatch motor control circuits and the door will release.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.